VQ DHC-2 Beaver 2850mm Wingspan ARF kit -VQA066
De Havilland Canada DHC-2 Beaver (30cc size EP/GP - civilian category)
DHC-2 Beaver History:
First flown in 1947 and produced until 1967 a total of 1657 Beavers were completed. With the typical 450HP nine-cylinder radial engine the Beaver has a useful load of 2100 pounds.
Τhe de Havilland Canada DHC-2 Beaver is a single-engined, high-wing, propeller-driven, STOL aircraft developed by de Havilland Canada, primarily known as a bush plane. It is used for cargo and passenger hauling, aerial application (crop dusting and aerial topdressing), and has been widely adopted by armed forces as a utility aircraft. The United States Army purchased several hundred; nine DHC-2s are still in service with the U.S. Air Force Auxiliary (Civil Air Patrol) for search and rescue. A Royal New Zealand Air Force Beaver supported Sir Edmund Hillary's expedition to the South Pole. Over 1,600 Beavers were produced until 1967 when the original line shut down.
Due to its success, the Royal Canadian Mint commemorated the Beaver on a special edition Canadian quarter in November 1999.
This a scale version with several details inclunding also and one remote control door (for pilot's door), also need an extra servo for open-close. Beaver is a known 'STOL' workhorse capable of operating in rugged, short-field conditions for light transport roles, both civilian and military.The professional Painted Fiberglass Cowl as well as All Pre-Hinged Control surfaces, quarantee less time than you can imagine to Fly this incredible replica RC plane.
- All Balsa and lite-ply construction
- Fully covered in weathered detail
- Fiberglass cowling
- Control surfaces pre-hinged and installed
-Two piece wing with aluminium wing joiner
- Pilot door and rear door can open-close
- Big battery hatch for Electric version
What's in the Box:
- Assembly instructions with stage photos
- Plywood seat
- Fiberglass cowling
- Aluminium landing gear , & Wheels
- Landing Struts
- Aluminium wing joiner
- Wing struts
- Engine mounts
- Fuel tank
- Decals and all hardware
What you Need to Fly:
Radio System (Transmitter, Receiver, Servos)
Power System (Brushless Power or nitro),
Battery Pack, Glue, Silicone Fuel Line (for nitro engine, Fuel, and electric starter)
Work for Assembly, setup etc..
|Size and Weight Informations|
|Weight||RTF: 6.5 - 8.0 kg|
|Servos||7~8 servos (Rec. MKS HV777)|
|Recommended||Brushless Motor Scorpion S55 series (S-5535-160KV with 12s Lipo (2x 5000mAh 6S, 40~60C)|
|Wireless Devices and FPV Equipment|
|Power||- Gas engine: 30cc - Electric motor: 160KV w/Lipo 22.2V - 5000 mAh x 2|